Évaluer
Les évaluations seront publiées après vérification.

Les champs avec un * sont obligatoires.
En cliquant sur "Envoyer" ou "Valider" j'accepte que mes données personnelles soient traitées conformément à la politique de confidentialité de SCOOTER CENTER GmbH.

 
 
L'article a été ajouté.

Lambretta (Innocenti) TV 175 (série 1)

Lambretta (Innocenti) TV 175 (série 1)

Description


Lambretta TV 175
Series 1

The TV was Innocenti's new flagship, but it was not without problems as the engine had a few design flaws, especially the clutch was too weak. Still it was a milestone for Innocenti, forming the link between the old D models and all later models of the LI series. After only 10.086 scooter built, production of the TV Series I ceased in December 1958.

So the task of becoming the actual forefathers of all Lambrettas to follow was taken over by the “bread-and-butter” versions, the 125 and 150 LI, where all the design flaws of the TV had been done away with. Both engines were totally reliable and made the LI Series I a great commercial success for Innocenti with more than 150.000 scooters produced. The engines were already very similar to the usual LI type, even if the first models came without a chain tensioner and only one oil seal in the mag housing, which was lubricated by the petrol/oil mixture. This was changed during the production run at the same time when the oil thrower under the front sprocket was added to ease life for the drive-side oil seal. Both the chain tensioner and the grease-lubricated flywheel bearing became standard with all subsequent Lambrettas, so that the final design of the Lambretta engine was reached further improvements mainly were aimed at strengthening certain parts like the crank and its bearings.

Apart from minor differences the bodywork of the LI is identical to that of the TV 175. The little design alterations are rather there to highlight the status of the models. For instance, the LI 150 had alloy floorboard strips with rubber inlays and end caps, while the LI 125 only came with simple alloy ribs. The handlebar-ends were painted at the 125, while they were from polished alloy at the 150. The rubber parts and cables are grey at both models, with the notorious exception of the black stand feet and kickstart rubber of course. Not to forget the gasket under the rear light, which is coloured white. Colour schemes are two-tone grey for the LI 125, while the LI 150 boasts a number of options, including two-tone versions with grey base and blue, green or red side-panels and horncasting.

Model:
Capacity:
Production period:
Quantity:
Production code:
1st frame no.:
TV 175
175 cc
09/57-12/58
10.089
175TV
1.001

 

TV series 1 – 1st version
(September 1957 until April 1958)

The air intake is now between the seats via an airbox, with an oval air filter. The tank vent is now through the filler cap. The brake-pedal receives a small splashplate.

 

TV series 1 – 2nd version
(May until July 1958)

Horn grille is a separate piece screwed into the horncasting, the ball-bearing in the mag housing is replaced by a roller bearing. The splashplate at the main stand is introduced. The centre hub at the rear hub is secured by a locking washer.

 

TV series 1 – 3rd version
(August until December 1958)

The adjustable levers are discontinued.

 

Original paint (Lechler)

 

Avorio (Elfenbein)
8028
Farbkarte

 

 
Véhicule (généralités)
Modèle: TV 175 (série 1)
Année/s de production: 1957, 1958
N° de châssis: 175TV
Production: 10089
Couleurs: avorio (8028)
Véhicule dimensions
Longueur: 1825 mm
Largeur: 710 mm
Hauteur: 1038 mm
Hauteur de la selle: 787 mm
Hauteur du marchepied: 165 mm
Distance entre les axes de roues: 1290 mm
Capacité réservoir d'essence: 8.5 l
Réserve incl. (essence): 1.2 l
Poids (à vide): 120 kg
Véhicule roues
Roue avant: 3.50 - 10
Roue arrière: 3.50 - 10
Jante avant: 2.15 - 10
Jante arrière: 2.15 - 10
Véhicule freins
Type de frein avant: frein a tambour
Actionnement de frein avant: mécanique par câbles
Ø avant: 150 mm
Type de frein arrière: frein a tambour
Actionnement de frein arrière: mécanique par câbles
Ø arrière: 150 mm
Véhicule suspension
Type de suspension avant: amortisseur et ressort séparés, fourche, suspension à roue tirée
Type de suspension arrière: combiné ressort/amortisseur
Véhicule moteur
Cylindrée: 170 cm³
Course: 60 mm
Alésage: 60 mm
Type de moteur: 2 temps
Nombre de cylindres: 1
Type de refroidissement: par aire
Puissance (kW): 6.33 kW
Puissance (ch): 8.6
Régime max. de rotation (puissance max.): 6000
Compression: 1:7.6
Carburation: carburateur
Carburateur: Dell'Orto MB23 BS5
Démarreur: kick
Embrayage: manuel
Fabricant du moteur: Innocenti
Vitesse max.: 103 km/h
Type de moteur: 2 temps
Norme d'emissions: sans
Véhicule moteur - allumage
Type d'allumage: avec rupteur
Avance à l'allumage: 27
Écartement des contacts: 0.45 mm
Puissance (éclairage): 30 W
Tension: 6 V
Bougie: (NGK) B7ES
Véhicule moteur - boîte de vitesses
Boîte de vitesses: manuelle
Nombre de vitesses: 4
Véhicule fluides
Carburant: Super (ROZ 95)
Mélange: 1:16
Huile de transmission: SAE30
Quantité huile de transmission: 1 l
Les clients recherchaient alternativement
Derniers produits consultés