Evaluar
Las evaluaciones serán publicadas tras una comprobación.

Los campos marcados con * son obligatorios.
Al hacer clic en "Enviar" o "Guardar" consiento que mis datos personales sean tratados conforme a los términos y condiciones de la política de privacidad de SCOOTER CENTER GmbH.

 
 
El artículo se ha añadido correctamente.

Lambretta (Innocenti) TV 175 (serie 1)

Lambretta (Innocenti) TV 175 (serie 1)

Descripción


Lambretta TV 175
Series 1

The TV was Innocenti's new flagship, but it was not without problems as the engine had a few design flaws, especially the clutch was too weak. Still it was a milestone for Innocenti, forming the link between the old D models and all later models of the LI series. After only 10.086 scooter built, production of the TV Series I ceased in December 1958.

So the task of becoming the actual forefathers of all Lambrettas to follow was taken over by the “bread-and-butter” versions, the 125 and 150 LI, where all the design flaws of the TV had been done away with. Both engines were totally reliable and made the LI Series I a great commercial success for Innocenti with more than 150.000 scooters produced. The engines were already very similar to the usual LI type, even if the first models came without a chain tensioner and only one oil seal in the mag housing, which was lubricated by the petrol/oil mixture. This was changed during the production run at the same time when the oil thrower under the front sprocket was added to ease life for the drive-side oil seal. Both the chain tensioner and the grease-lubricated flywheel bearing became standard with all subsequent Lambrettas, so that the final design of the Lambretta engine was reached further improvements mainly were aimed at strengthening certain parts like the crank and its bearings.

Apart from minor differences the bodywork of the LI is identical to that of the TV 175. The little design alterations are rather there to highlight the status of the models. For instance, the LI 150 had alloy floorboard strips with rubber inlays and end caps, while the LI 125 only came with simple alloy ribs. The handlebar-ends were painted at the 125, while they were from polished alloy at the 150. The rubber parts and cables are grey at both models, with the notorious exception of the black stand feet and kickstart rubber of course. Not to forget the gasket under the rear light, which is coloured white. Colour schemes are two-tone grey for the LI 125, while the LI 150 boasts a number of options, including two-tone versions with grey base and blue, green or red side-panels and horncasting.

Model:
Capacity:
Production period:
Quantity:
Production code:
1st frame no.:
TV 175
175 cc
09/57-12/58
10.089
175TV
1.001

 

TV series 1 – 1st version
(September 1957 until April 1958)

The air intake is now between the seats via an airbox, with an oval air filter. The tank vent is now through the filler cap. The brake-pedal receives a small splashplate.

 

TV series 1 – 2nd version
(May until July 1958)

Horn grille is a separate piece screwed into the horncasting, the ball-bearing in the mag housing is replaced by a roller bearing. The splashplate at the main stand is introduced. The centre hub at the rear hub is secured by a locking washer.

 

TV series 1 – 3rd version
(August until December 1958)

The adjustable levers are discontinued.

 

Original paint (Lechler)

 

Avorio (Elfenbein)
8028
Farbkarte

 

 
Vehículo (general)
Modelo: TV 175 (serie 1)
Año/s de producción: 1957, 1958
N.° de chasis: 175TV
Unidades fabricadas: 10089
Colores: avorio (8028)
Vehículo dimensiones
Longitud: 1825 mm
Anchura: 710 mm
Altura: 1038 mm
Altura del asiento: 787 mm
Altura al estribo: 165 mm
Distancia entre ejes: 1290 mm
Capacidad depósito combustible: 8.5 l
Reserva incl. (combustible): 1.2 l
Peso (en vacío): 120 kg
Vehículo ruedas
Rueda delantera: 3.50 - 10
Rueda trasera: 3.50 - 10
Llanta delantera: 2.15 - 10
Llanta trasera: 2.15 - 10
Vehículo frenos
Tipo de freno delantero: freno de tambor
Accionamiento del freno delantero: mecánico con cables
Ø delantero: 150 mm
Tipo de freno trasero: freno de tambor
Accionamiento del freno trasero: mecánico con cables
Ø trasero: 150 mm
Vehículo suspensión
Tipo de suspensión delantera: amortiguador y muelle separados, horquilla adelantada
Tipo de suspensión trasera: conjunto muelle-amortiguador
Vehículo motor
Cilindrada: 170 cm³
Carrera: 60 mm
Diámetro: 60 mm
Tipo de motor: 2 tiempos
Número de cilindros: 1
Tipo de refrigeración: por aire
Potencia (kW): 6.33 kW
Potencia (cv): 8.6
Revolución por minuto (potencia máx.): 6000
Compresión: 1:7.6
Alimentación: carburador
Carburador: Dell'Orto MB23 BS5
Arranque: pedal
Embrague: manual
Fabricante del motor: Innocenti
Velocidad máx.: 103 km/h
Tipo de motor: 2 tiempos
Norma de emisión: sin
Vehículo motor - encendido
Tipo de encendido: con platinos
Avance de encendido: 27
Distancia entre contactos: 0.45 mm
Potencia (luz): 30 W
Tensión: 6 V
Bujía: (NGK) B7ES
Vehículo motor - caja de cambios
Caja de cambios: manual
Número de velocidades: 4
Vehículo líquidos
Carburante: Super (ROZ 95)
Mezcla: 1:16
Lubricante engranaje: SAE30
Cantidad lubricante engranaje: 1 l
Los clientes buscaron alternativamente
Productos vistos últimamente