Carburator -PINASCO SI28/28ER- Vespa Largeframe - PX, Sprint, Rally, Cosa, VNA2, VNB, VBA, VBB, GT, GTR, TS, Super | Carburettors | Carburettor | Engines

Preview: Carburator -PINASCO SI28/28ER- Vespa Largeframe - PX, Sprint, Rally, Cosa, VNA2, VNB, VBA, VBB, GT, GTR, TS, Super

Description

The Pinasco SI28 ER has a passage of Ø=28mm. This gives it 36% more suction surface than a conventional SI24, on which the design of the SI28 ER is based. The body is slightly larger, but the tuning parts can be taken from the original Dell'Orto/Spaco SI types, except the air filter. The float chamber is 5mm higher to prevent slimming on powerful engines. The generally enlarged petrol holes in the carburettor serve the same purpose.

SI-typically the basic tuning is set via air nozzle and mixing tube, the fine tuning is done via secondary nozzle, main nozzle and the air filter.

ASSEMBLY INSTRUCTIONS

Only suitable for PX Lusso carburetor sump
Original air filter not suitable (diameter of air inlet + idle screw at another position)
Mixing screw is not aligned with the hole in the tub (shorten and slit the screw)
Note the length of the M7 stud bolt supplied, these are, depending on the depth of the thread in the motor housing, too short (if possible then if necessary (if possible do not screw in completely and secure with Loctite)
outlet tube of the float chamber overflow is not aligned with the carburettor sump (drill/adjust otherwise the carburettor can get stuck)
drillings In the carburettor body for the M7 stud bolts are very narrowly tolerated, if necessary expand them a little

The SI28 ER is not intended for vehicles with separate lubrication. On models with oil pump the mixture itself must be premixed in the fuel tank. The oil pump itself can be stopped by simply pulling the oil pump shaft out of the engine housing (under the carburettor sump). It is recommended to adjust the carburettor sump to the larger diameter. Enclosed are extended M7 studs with shaft nuts. These replace the original studs or the hexagon socket studs used from 1984 onwards.

INDUSTRATION

Air correction nozzle: 160
Mixing tube: BE2
Auxiliary nozzle: 55/160
Gas slide (asymmetrical and wider) with air pocket on the bottom side

FAZIT: Perfect for unobtrusive but powerful road tuning.

NOTE: Please note that the air nozzle should always be tuned in conjunction with the air filter/air funnel. An air funnel needs e.g. a smaller air nozzle than a completely closed filter. The secondary nozzle has a wide range of action in the SI. Its flow rate must always be added to the main nozzle. Thus, a mere change to a smaller secondary nozzle may require a larger main nozzle at the same time to keep the mixture at the same level in the upper speed range.

_{AI-translation}

€249.00 *

incl. VAT plus shipping costs

Available immediately (delivery time 1-3 working days*)

P For this item you get fidelity point/s

OEM numbers (for comparison purposes only)
Pinasco	26295020

Customers alternatively searched for
Vergaser \| Vergaßer \| BigBore \| 28mm \| 28 \| Durchmesser \| SI \| SI28 \| SI 28 \| Big Bore \| Oversize \| Gaser \| Zerstäuber \| Carburator \| Carburettor \| Carburetor \| Carb \| Carburateur \| Carburatore \| Carburador \|