Carburator -MIKUNI 38mm TMX38- manual choke - powerjet - CS=45mm | Carburettors | Carburettor | Engines

Preview: Carburator -MIKUNI 38mm TMX38- manual choke - powerjet - CS=45mm

Description

The carburettors from the Japanese manufacturer Mikuni are in the reference class when it comes to perfect tunability and thus the highest achievable performance with optimum consumption. Mikuni carburettors and parts are manufactured with tolerances of 5/1000ths. This is one of the reasons why they run so perfectly. However, you should take a little time for tuning, because Mikuni carburettors do not run with any carburettor equipment, but only with the really suitable one. But they run perfectly and you don't expose the engine to the risk that it only runs well in some partial load ranges and then goes up in one of the other partial load ranges.

The TMX 38 works well on Vespa largeframe and 180cc automatic engines above 30hp. The basic setup is usually already very good here.

The Mikuni carburettors react quickly to fine contamination of the fuel with an overflow of the float chamber. The TMX 38 offers the possibility to tune the carburettor in the middle speed and slide valve range with the Powerjet nozzle to gain power and reduce consumption. In order to prevent a leaning in the upper slide and speed range, the Powerjet nozzle is used, which additionally feeds petrol into the intake flow due to the high vacuum at full throttle and high speeds.

Main nozzle: 410
Idle jet nozzle: 20
Needle nozzle: R-6 ( 633 )
Nozzle needle: 6EJ12-56-3
Starter nozzle: fixed
Idle jet propeller: 2.0 turn
Main air nozzle: without
Power Jet nozzle: 50
Gas slide: 3.5
Needle valve: 3.5
Float level: 20mm
Choke actuation: left / knob
Standing gas screw: left
Air screw: left
Outer diameter front: 44mm
Outer diameter rear: 62mm
Overall length: 76mm
Measurement center venturi up: 82mm
Measurement center venturi down: 80mm
Fuel supply: left
Power Jet: up

_{AI-translation}

€319.00 *

incl. VAT plus shipping costs

Available immediately (delivery time 1-3 working days*)

P For this item you get fidelity point/s

Carburettors
size venturi:	38 mm
size main jet:	410
main jet type:	Mikuni (4/042)
size pilot jet:	20
idle jet type:	Mikuni (VM22/210)
size needle:	6EJ12-56
needle type:	Mikuni
size atomiser:	R-6 (Serie 633)
power jet:
size power jet:	50
power jet type:	Mikuni (N100606)
size slide:	3,5
slide type:	D-shaped slide
choke type:	manual button
mounting type air filter:	rigid
connection size air filter:	62 mm
mounting type intake manifold:	rubber mounted
connection size intake manifold:	44 mm
idle gas screw:	left hand side
fuel/air mixture screw position:	left hand side
fuel hose position:	left hand side
depth:	76 mm
connection height (relative):	80 mm
material float chamber:	metal
connector for oil hose:
vacuum connection: