Carburator -MIKUNI 35mm TMX35- manual choke - CS=40mm | Carburettors | Carburettor | Engines

Preview: Carburator -MIKUNI 35mm TMX35- manual choke - CS=40mm

Description

The carburettors from the Japanese manufacturer Mikuni are in the reference class when it comes to perfect tunability and thus the highest achievable performance with optimum consumption. Mikuni carburettors and parts are manufactured with tolerances of 5/1000ths. This is one of the reasons why they run so perfectly. However, you should take a little time for tuning, because Mikuni carburettors do not run with any carburettor equipment, but only with the really suitable one. But they run perfectly and you don't expose the engine to the risk that it only runs well in some partial load ranges and then goes up in one of the other partial load ranges.

The TMX 35 works well on Vespa largeframe and 180cc automatic engines above 25hp. The basic setup is usually already very good here.

The Mikuni carburettors react quickly to fine contamination of the fuel with an overflow of the float chamber. Therefore it is ideal to use a good fuel filter.

Main nozzle: 350
Idle nozzle: 20
Needle nozzle: fixed
Nozzle needle: 6EN11-53-3
Starter nozzle: fixed
Idle air screw: 1.25 turn
Main air nozzle: fixed
Gas slide: 6.0
Needle valve: 3.5
Float position: 20mm
choke actuation: left / button >/li>
Standing gas screw: left
Air screw: left
Outer diameter front: 40mm
Outer diameter rear: 62mm
Overall length: 74mm
measurement center venturi up: 85mm
measurement center venturi down: 77mm
fuel supply: left

_{AI-translation}

€249.00 *

incl. VAT plus shipping costs

Available immediately (delivery time 1-3 working days*)

P For this item you get fidelity point/s

Carburettors
size venturi:	35 mm
size main jet:	350
main jet type:	Mikuni (4/042)
size pilot jet:	20
idle jet type:	Mikuni (VM22/210)
size needle:	6EN11-53
needle type:	Mikuni
power jet:
size slide:	6
slide type:	D-shaped slide
choke type:	manual button
mounting type air filter:	rigid
connection size air filter:	62 mm
mounting type intake manifold:	rubber mounted
connection size intake manifold:	40 mm
idle gas screw:	left hand side
fuel/air mixture screw position:	left hand side
fuel hose position:	left hand side
depth:	76 mm
connection height (relative):	77 mm
material float chamber:	metal
connector for oil hose:
vacuum connection: